Posts by johngrese

    I'm having trouble installing RS Linux on my AarLogic C10/3. I have the s4 starterkit connected, and I'm using Hyperterminal to attempt to install the uImage.dat file. I've been following the steps in RS-Linux-Step_by_Step.pdf, and I'm not having any luck installing RS Linux.


    Here are the steps that I have been taking:
    1. I type "loady 0x20200000", and get the proper U-Boot> prompt.
    2. I send "uImage.dat" via ymodem protocol. That gives me: ## Total Size = 0x0013dedc = 1302236 Bytes
    3. "cp.b 0x20200000 0xd0021000 0x0013dedc". This is where the problem comes in. When I type that command, I get the following error message:
    Unsupported combination of source/destination.


    That's the only error message that I get, so I don't have much to go on. My board is Rev. 5. What can I do to install RS Linux??? Please share you're experience, suggestions, or ideas.


    Thanks,
    John

    Hi, I actually got this issue figured out. The problem was the 'Baudrate' which was set in RSTerm. If I set the BaudRate in RSTerm to 115200, it works nicely.
    Any baudrate other than 115200 will not work for me on port X650. So, if anyone's having this same issue, try to change the baudrate in RSTerm to 115200 and see if you're able to enter your linux commands.

    I am using a Aarlogic C10/3 with the STK-4 starter kit.
    It seems that my unit won't respond from the X650 serial port when I try to access it through RS-Term. When I connect to X650, I am unable to enter any text into the terminal.


    When I connect the X300 port and type 'AT' in RS-Term, I get 'OK' as a response. When I type 'AT+CGMR', I get '07.03.942' as a response.


    But, when I'm connected to the linux port (X650), I cannot enter any text into RS-Term. Also when I click 'AutoDetect' in RS-Term, I get 'Sorry, No Modems Found!'.


    Could anyone please help me out, I have been stuck here for several days, and I can't move any further until I can get this straightened out.


    Thanks!

    I am using a GE683-Pro3 with the STK-4 starter kit.
    It seems that my unit won't respond from the X650 serial port when I try to access it through RS-Term. When I connect to X650, I am unable to enter any text into the terminal.


    When I connect the X300 port and type 'AT' in RS-Term, I get 'OK' as a response. When I type 'AT+CGMR', I get '07.03.942' as a response.


    But, when I'm connected to the linux port (X650), I cannot enter any text into RS-Term. Also when I click 'AutoDetect' in RS-Term, I get 'Sorry, No Modems Found!'.


    Could anyone please help me out, I have been stuck here for several days, and I can't move any further until I can get this straightened out.


    Thanks!