Problem during Upload file

  • Hello everyone,


    I use the GM862 module for localise my vehicule, but I want to work on my laptop (no Serial output).
    I bought a cable converter RS232 to USB.
    But when I click on "upload selected file(s) from pc to module", (AT#WSCRIPT='main.pyo'), I have this message appears "Please change COM settings to baudrate 115200 and flowcontrol Hardware"
    In tab INIT the serial port setup is configure with the following parameters:
    Port R = COM3 (Prolific USB-to serial Comm Port)
    Baudrate = 115200
    * Flowcontrol = Software


    * I already try to put Flowcontrol = Hardware
    But I have 2 problems:
    I don't have the prompt and when I click on "upload selected file(s) from pc to module", I have this message: "File(s) not uploaded: C:\Telit\source\main.pyo no prompt


    I use the module GM862-GPS with the following firmware 7.03.402 (the firmware is already put today)
    I use Rsterm for put my script.
    COM setting under Windows XP, ~Hardware Properties ==> Port Parameters :
    Bits rate = 115200
    Data Bits = 8
    Parity = None
    Stop bit = 1
    Flowcontrol = Hardware.


    I hope my explanations is clearly

  • Quote

    But when I click on "upload selected file(s) from pc to module", (AT#WSCRIPT='main.pyo'), I have this message appears "Please change COM settings to baudrate 115200 and flowcontrol Hardware"


    The hw flowcontrol is mandatory.