FTP - exiting from data

  • Q: Type of module? A:862
    Q: Firmware version? A: latest
    Q: Type of starter kit you have?
    (S1, S1B, S2, S3, S4, EVK1, EVK2, none, other)


    I have an FTP connection and all the following work fine:


    FTPLIST
    FTPGET
    FTPCLOSE


    I have found FTPOPEN xxxxxxxxxx, 1 to work best.


    I am trying to use FTPPUT to upload an ascii file. I get CONNECT fine and I can see the data tx led flash on my PC so I know the data is presented ok to the Telit Module.


    The trouble is I cant get the module to exit from the data mode to command mode. I send CR +++ CR as instructed. The manual says check S12 parameter - what is that please?


    Thanks again for your help


    rgds


    mb

  • Quote

    I send CR +++ CR as instructed.


    you msut do this as follows:


    data <wait 1sec> <send +++ without CR><wait 1sec>


    Quote

    S12 parameter


    There you set the guard time.
    See ATS12 command for more information.