Dashboard

Recent Activities

  • iotah

    Replied to the thread HTTPSND.
    Post
    Hi Mazen,

    Thank you for responding. Sorry for my lateness of my response, I had given up on getting any response at all.

    I used MDM.Send to issue the relavant AT commands:

    AT#SSLEN=1,0 ; I did this just to make sure it wasn't enabled
    AT#SGACT=1,1
  • Hüseyin

    Thread
    Hi All,



    After 6/ April 2019 (GPS roll over event) customers using modules based on Sirf4 GSD4E-9333 chipset, noticed issues related to Satellite tracking. Touching base with Qualcomm Leads into a firmware patch that is mandatory to be upload into the
  • joeim

    Replied to the thread Require new firmware for UL865-EUR.
    Post
    Hello,
    I'm in the the same situation. Need latest firmware for UL865-EU.
    Thanks
  • Mazen

    Post
    Hi,

    This is because the GPS doesn't have a fix yet. Once you get a position fix, you will get a complete answer with coordinates. make sure you are using the right antenna and that the antenna has a clear view to sky. If you are using an active…
  • Mazen

    Replied to the thread HTTPSND.
    Post
    Hi,

    Which port are using to access the AT controller? The same port that you have uses to send the command HTTPSND, should be used to send the data to be posted. Could you post your complete AT commands sequence you are using and the answer you are…
  • iotah

    Posted the thread HTTPSND.
    Thread
    Hi,

    I am investigating HTTPSND to post data to a web server. I am not sure how to interpret the definition regarding the output of the '>>>' and how to set the data string. It implies that the the '>>>' is output to a serial device (USB0)? rather than…
  • abu1194

    Post
    hi,
    and now when i again tried this command, it worked but the coordinates that gps is given is false and weird like GPSACP: ,,,,,1,,,,,
  • abu1194

    Post
    Hi Mazen,
    i tried it, but still it gives me the gollowing error:
    CME error: operation not allowed
  • Mazen

    Post
    Hi,

    You need to send first the following command: AT$GPSP=1
    After that you can start querying the coordinates with AT$GPSACP
  • abu1194

    Thread
    i need to get guidance related to the accessibility of gps coordinates from TELIT HE910 module, it has gps and i am using the AT commands, but on using the command AT$GPSACP, it just shows $GPSACP: and OK,
    what might be the reason for this and when i do…