You are not logged in.

1

Wednesday, August 1st 2012, 11:41pm

Problem during Upload file

Hello everyone,

I use the GM862 module for localise my vehicule, but I want to work on my laptop (no Serial output).
I bought a cable converter RS232 to USB.
But when I click on "upload selected file(s) from pc to module", (AT#WSCRIPT='main.pyo'), I have this message appears "Please change COM settings to baudrate 115200 and flowcontrol Hardware"
In tab INIT the serial port setup is configure with the following parameters:
Port R = COM3 (Prolific USB-to serial Comm Port)
Baudrate = 115200
* Flowcontrol = Software

* I already try to put Flowcontrol = Hardware
But I have 2 problems:
I don't have the prompt and when I click on "upload selected file(s) from pc to module", I have this message: "File(s) not uploaded: C:\Telit\source\main.pyo no prompt

I use the module GM862-GPS with the following firmware 7.03.402 (the firmware is already put today)
I use Rsterm for put my script.
COM setting under Windows XP, ~Hardware Properties ==> Port Parameters :
Bits rate = 115200
Data Bits = 8
Parity = None
Stop bit = 1
Flowcontrol = Hardware.

I hope my explanations is clearly

2

Thursday, August 2nd 2012, 1:21pm

RE: Problem during Upload file

Quoted

But when I click on "upload selected file(s) from pc to module", (AT#WSCRIPT='main.pyo'), I have this message appears "Please change COM settings to baudrate 115200 and flowcontrol Hardware"


The hw flowcontrol is mandatory.

Rate this thread